Ringotron vs midifruuze

Ringotron allows taming the strong transformational effects of traditional ring modulation, opening up a wider range of possibilities in sound design and audio FX. Its multi-band design enables fine control over which parts of the spectrum will be transformed by the effect. A special soft mode is available that borrows concepts from feedback modeling, which can be used to reduce intermodulation effects that are often a limiting factor in the more general applicability of ring modulators. In addition to the layers of control they provide, combination of these core features also allows the plugin to act as a stereo, multi-peak resonant filter that can also smoothly morph into a ring modulator. FEATURES: • 2 parallel ring modulator units (max. modulator frequency: 8 kHz) • Stereo separation can be added to band center, mod. frequency, mod. phase • Ultra-narrow bands can be used to create highly resonant sounds • 4 large ribbon controls for band center and modulator frequencies • Band center frequencies can be modulated by the built-in modulation system • Tempo syncing can be independently configured for each oscillator • Built-in soft limiter and clipper to protect against volume spikes IMPORTANT INFORMATION: The plugin comes with a zero-latency, non-brickwall soft limiter, and as such, its stopping power is limited. Make sure to always leave enough headroom or use an external brickwall limiter for total protection against powerful transients. Alternatively, a built-in soft clipper is also available. PLEASE NOTE: • AUv3-compatible host app is required • Suported sampling rates: 44.1, 48, 96 kHz

midifruuze is a live midi sampler and effect This app allows you to capture recent 10 seconds of incoming MIDI data and replay it using different available playback modes Currently this app supports all channel messages; MIDI SysEx, System Common and Realtime messages are not supported Playback modes: * "Scrub Pitch” / “Scratch Pitch”: Transposes notes according to touch vertical position; keeps note velocity. “Scrub” doesn’t output the same note during position change. * "Scrub Velocity” / “Scratch Velocity”: Changes note velocity according to touch vertical position. “Scrub” doesn’t output the same note during position change. * “Freeze” Repeats selected note according to rate selected by touch position. Vertical touch position changes velocity * "Hit": plays single note when pressed; vertical position changes velocity Standalone and AUv3