Ejecta vs Water Eject Speaker Clean

Water in your speaker? Press one button. Ejecta plays a low tone that makes the speaker cone travel far enough to push the water out through the grille. It is the same trick the Apple Watch uses, and it takes a minute. THE FREE CYCLE IS FREE FOREVER Sixty seconds of real ejection — bursts at the frequency that moves a speaker cone furthest, then a sweep across the band, four passes. The same shaking knocks loose dust off the grille, so it helps there too. No trial, no countdown, no card. POWER EJECT, IF YOU WANT IT Two minutes, louder, six passes and a wider frequency sweep for a speaker that is still muffled. One purchase, and it is yours forever. DUST CYCLE Ninety seconds of higher, faster tones, aimed at loose dust instead of water. A droplet needs the cone to travel, which is why the water cycles sit low; a speck of dust needs it to shake, so this one works an octave and a half further up. SPEAKER TEST Play one channel at a time and hear which speaker is quiet, buzzing or muffled. Your ear does the judging — nothing here invents a score. TONE GENERATOR Hold any tone from 20 Hz to 20 kHz, with presets. For testing gear, checking your hearing range, or finding a rattle. WHAT IT WILL NOT DO It cannot clear your charging port — there is no speaker in there to push with. It does not dry anything: the water is physically shoved out, not evaporated. It shakes loose dust off a grille, but it cannot lift dirt packed in over months — that needs a soft dry brush, and the app tells you so. There is no moisture meter in this app, because a phone cannot measure that, and any app showing you a percentage is making it up. The in-app tips page says all of this before you buy anything. NO SUBSCRIPTION. NO ACCOUNT. NO PERMISSIONS. Ejecta asks for nothing — not the microphone, not your contacts, not an email address. Audio only goes out. One optional purchase, Family Sharing included. Turn the volume all the way up and point the speaker at the floor. That is the whole instruction. Requires iPhone with iOS 17 or later. Privacy Policy: https://transformly.app/ejecta/privacy Terms of Use: https://transformly.app/ejecta/terms Support: afigaliyevdev@gmail.com

Water in your iPhone speaker? If the sound is muffled, Water Eject plays a 15-second low-frequency sound sweep to help push water from the main speaker grille. How it works 1. Turn your volume all the way up. 2. Hold your iPhone with the main speaker facing down. 3. Place a paper towel underneath. 4. Tap Eject Water. The app plays a 200 Hz to 120 Hz sound sweep for 15 seconds. The speaker membrane vibrates during the sweep, helping push water droplets out through the grille. When the session ends, listen to your speaker. If it still sounds muffled, you can run the session again. Designed to run when it matters Water Eject will not start when headphones or an external audio output is connected. It also warns you when the volume is too low for the sweep. If an audio interruption occurs, such as a phone call, the session stops. What it does not do Water Eject cannot detect whether water is present and cannot measure whether the process worked. Your own ears are the only way to tell if the speaker sounds clearer. It helps push water from the main speaker. It does not clean the earpiece, charging port, or microphone. It is not waterproofing, a moisture sensor, or a repair. If your iPhone has sustained water damage or the speaker remains affected, seek appropriate service. One purchase. No subscription. Water Eject is a one-time purchase. There is no subscription, no advertising, and no account required. Open it when you need it, run the 15-second sweep, and check the sound. Terms of Use: https://barissemerci.github.io/water-eject/terms/