Water Eject vs Water Eject & Dust

When an iPhone speaker sounds muffled after a splash, Water Eject provides a focused acoustic routine and clear care guidance. Quick Clean is free and unlimited. Controlled low-frequency sweeps play through the built-in iPhone speaker while you keep the speaker side facing down. QUICK CLEAN — FREE AND UNLIMITED Quick Clean runs a 30-second bidirectional sweep from 150 to 210 Hz with smooth ramps and an app-defined amplitude limit. Cleaning requires the built-in iPhone speaker route. If headphones, AirPods, Bluetooth audio, or a wired output is active, the routine stops and explains how to switch output safely. ENHANCED CLEAN — LIFETIME ACCESS Enhanced Clean is a 52-second four-stage routine with 120 to 240 Hz sweeps and pulsed frequency holds. It is 73% longer than Quick Clean and uses twice the sweep range. These are transparent routine differences, not a performance guarantee or repair claim. One lifetime purchase unlocks every diagnostic tool. There is no subscription. GUIDED BEFORE & AFTER COMPARISON Run a repeatable three-band probe before and after a routine. Water Eject reports relative low, mid, and high frequency change as Stronger, Similar, Lower, or Inconclusive. It never labels a speaker wet, dry, repaired, or damaged. Unreliable comparisons are rejected when conditions change. Microphone access is optional and requested only when you explicitly begin Guided Compare or Mic Check. Audio samples are processed temporarily on your device and are not saved. Raw buffers stay in memory only. If microphone access is unavailable, you can still record a manual Better, Same, or Worse result. Cleaning itself does not need microphone permission. SOUND TOOLS Explore a bounded low-frequency lab, speaker channel checks, and bass, mid, and treble test tones. Use left and right checks with connected headphones or AirPods, or make an optional voice microphone recording for playback. AirPods and other headphones are used only for diagnostic listening; water-ejection routines are never played to them. Speaker playback cannot clean a microphone. LOCAL HISTORY Keep a private on-device record of routine, duration, derived comparison summary, and your result rating. Raw microphone audio is never saved. Clear history inside the app with an explicit confirmation. SAFE CARE GUIDE Follow practical preparation and drying steps based on conservative device-care guidance: remove cases that trap moisture, disconnect cables, place the speaker side down, and allow airflow. Learn why you should avoid heat, compressed air, rice, and objects inserted into openings. The guide also explains liquid-alert precautions and when persistent distortion, charging trouble, heat, or other symptoms deserve professional service. IMPORTANT LIMITS Acoustic pulses may help move light moisture near an exposed speaker mesh, but results vary. Water Eject does not add liquid protection, repair liquid damage, remove packed debris, or affect microphone mesh through speaker playback. Allow drying time and seek qualified service when symptoms persist. DESIGNED FOR CONTROL AND PRIVACY Playback stops on route changes, interruptions, calls, and backgrounding. Water Eject works without an account and does not upload microphone recordings. Choose your in-app language at any time, including right-to-left languages. Unlock lifetime access once to add Enhanced Clean, Guided Compare, manual frequency tools, speaker and headphone checks, microphone playback check, and local history. Quick Clean and the complete care guide remain available without payment. PURCHASE AND PRIVACY: - Lifetime access is available as a one-time non-consumable purchase. There is no subscription. - Payment will be charged to your Apple ID at confirmation of purchase. - Restore Purchases can restore lifetime access when you use the same Apple ID. Terms of Use: https://www.apple.com/legal/internet-services/itunes/dev/stdeula/ Privacy: https://yumcut.com/mobile/privacy

Water Eject plays three rounds at the bottom speaker grille to shake water droplets loose: the pulsed low tone Apple Watch uses after a swim, then a short broadband pulse, then a higher band. It works on the bottom speaker, not on the earpiece, the microphone or the charging port. Hold the phone speaker-down and press Start. Round 1, Low Sweep, 21 seconds. A sweep around the centre you set on the dial, anywhere from 120 to 260 Hz. Then the tap step. Tap the phone gently against your palm, speaker down, until it chimes. That is Apple's own advice for a wet iPhone, and the app counts the taps and moves on by itself. Round 2, Pulse Shots, 18 seconds. Short broadband pulses. The tap step again. Round 3, High Sweep, 12 seconds. A sweep from 400 to 1,000 Hz. Session complete. Let it dry before charging. The tone runs 51 seconds across the three rounds, and the two tap steps sit between them. Drops shake out of the disc on screen while the tone plays, and the phone pulses in your hand with it. The dial sets the centre of the first round's sweep, from 120 to 260 Hz. Rounds 2 and 3 are fixed. How do you check the result? With microphone access and the volume all the way up, the app plays a short chime through the speaker before the session and again after it, then compares the two levels. It tells you whether the speaker came back louder, about the same, or quieter. It never shows a percentage. Play it through the iPhone's own speaker. Disconnect headphones, AirPods or a Bluetooth speaker first, and turn the volume all the way up. It cannot dry the inside of a phone. If the speaker still sounds muffled after a session, let it dry and come back to it. Made for anyone whose iPhone just came out of a pool, the rain, the shower or the sink. Your first session is included. After that, one purchase unlocks unlimited sessions for good: nothing renews, and there are no ads. No account is needed, and the tone is made on the iPhone itself. You can start a session with Siri: say "Start a run in Water Eject" and the app opens and plays the tone. Hold the phone speaker-down and press Start. Terms of Use: https://cmlapps.github.io/watereject/terms.html Privacy Policy: https://cmlapps.github.io/watereject/privacy.html