Audio Function Generator vs PhaseChecker

This is the highly recommended and praised Function Generator App - an amazingly great and powerful tone generator. Enriched with a vast amount of features yet it is extremely intuitive and designed for simplicity. Get to know this great App now! It is very well maintained and has received considerable upgrades over the past years. So, … what can you do with this App? • PLAY TEST TONES Sine, Rectangular, Triangular and Sawtooth. • PLAY FREQUENCY SWEEP TEST TONES in both directions (minimum to maximum frequency and maximum to minimum frequency). • PLAY VOLUME SWEEPS (from minimum to maximum volume). • Try the SWEEP REPEAT / WOBBLE function. • Try the MUSIC TONES PLAYBACK. • Experiment with the huge FINE TUNE SELECTON, PRESETS SELECTION! • Or create your own CUSTOM PRESETS! • And SAVE an endless amount of CONFIGURATIONS (Frequency, Sweep, Noise) for later quick access and direct playback function. • Even play back different kinds of NOISE – White, Pink, Violet, Grey, Brown, Blue is also supported. The Function Generator is AMAZINGLY INTUITIVE and SIMPLE to use! AND THESE ARE THE ADVANCED SETTINGS/FEATURES (upgrade to PRO required): => Extending The Frequency Range (1Hz - 21kHz) => Extending The Sweep Times (0.1s - 600s) => Changing Min/Max Slider Frequency Ranges => Changing Max Sweep Time Slider Range => Changing Signal Amplitude => Enabling Of The Sweep Repeat / Wobble Function => Frequency Slider Setting to Linear or Logarithmic => Left/Right Channel Individual Selection => Permanently Saving Custom Presets => Saving Of Endless Number Of Audio Configurations => Phase Out Setting (custom phase shift of the generated signal) => BPM (Beats per Minute) Feature => Dual Function Generator => MultiTone Generator (playback of up to eight individual tones) => Background Theme Selection (Light/Dark) Check out the tutorial page: www.ee-toolkit.com/audio-function-generator

The PhaseCheck app will run a test signal through your sound system to ensure your speakers are in-phase and wired with the correct polarity. It can be run either manually or automatically.  Manual mode allows you to run the test signal and flip the phase so you can listen yourself to ensure your sound system is setup correctly.  Automatic mode will run a series of test signals through your sound system and use the microphone on the device to analyse the results. New in version 2.0 is a waveform view mode for advanced use. It allows you to play an asymmetrical waveform (ramp waveform), record the sound from each speaker close up and capture the waveforms to then compare them. Phase is a difficult concept so full help is available in the app to ensure you get the best results. You should check the phase of your sound system whenever the wiring has been changed to ensure everything is the correct polarity. When a sound systems speakers are out of phase the sound quality is affected massively. Bass is reduced significantly and stereo imaging gives the illusion of the sounds pulling outside of the room. To run the check connect your iOS device to your sound system so it can play audio. If possible place the iOS device evenly between the speakers. Phase cancellation will not occur close to the speakers so ensure the device is not too close. Ensure the volume is at a comfortable listening level and if possible ensure there is no background noise to interfere with the scan.