Mise à jour pas sympas 🤔
Jusqu’à présent, j’avais réussi à avoir un démarrage de l’application permettant d’être dès le démarrage sur l’onglet sécurité qui affiche d’une très belle manière l’état de la centrale et pas uniquement des petits boutons de couleur dans accueil ! Je remonte ma note dès que c’est possible à nouveau 😝
Show more
AAjimmy63
New update issue
On NVR can’t now rewind to a specific time……it scrolls and thinks about it then whizzes back to midnight of today. Both front and rear cams
SShaunguitar
Response from developer
Hello and thank you for your comment. This was rectified on an update after your comment. Could you please check for an App update. Thank you.
Lack of Notifications
Hi, I have the App as part of a monitored alarm system. I was recently called by the monitoring station with regard to a “low battery” signal that the panel had sent (15th October 2026). The “low battery” in question is in a wireless door sensor that actually flagged to the system on the 4th September 2026 so why the signal over a month later? Point I wish to make is that such “faults/flags” should result in a notification on the App rather than just being hidden in some sub-menu. Similarly a notification within the App would act as back-up when receiving calls from the monitoring station especially with the preponderance of scam and cold calls in this day and age. As the alarm siren itself was not sounding I ignored the monitoring station call thinking it was a scam until they called both our key-holders. More notifications please of system “faults” and/or signals to the monitoring station other than an actual alarm trigger. Thanks!
Show more
DDrewzel
Ajout fonction
Pouvez-vous ajouter la possibilité de programmer la mise en marche ainsi que la mise à l’arrêt de l’alarme via l’application ? Merci
RRENL0
Intermittent faults
Great when it works. Lots of faults connecting to panel, not setting alarm or off. Shouldn’t be this hard to sort this out in 2026
RRMF80
