New user
Does tell you car charge level
Customer service
Impressed. Ty yes either had a living person reach out to me and provide great feedback, or their AI robot is superior, lifelike, and helpful. Approved
Fails to show session data
The app has not managed to tell me how much energy it delivered in any session for months. The support people just brush it off. The scheduling barely works, and if you have a ToU plan, and the ToU peak period happens while your session is going, it will stop, but won’t resume after the peak period ends. They don’t seem to understand how ToU plans work and their scheduling support in the app shows this.
Show more
EVIQO
Amazing 5 start
New owner experience
Just installed this unit. Set it up for 48A charging. EV will only accept 48A not 50A but. It’s has the wiring for 50A.
I am the master electrician installing this for my shops new Ford E-Transit 350. Indoors at the panel. 60A std breaker (they don’t make GFCI for my square D panel for 60A 2P)
Line- Ran #6 to outdoor spa type 60A GFCI breaker.
Load of breaker to EVIQO charger. Removed factory wiring since it wouldn’t reach anyway. Ran thhn #6 in 1/2” Liquidtight to device. landed in device L1,L2,G connections.
Put everything together correctly. I’ve installed this same unit at a customer’s residence and it worked great.
Mine. Gave me an error. 8 flashes on the front of device. App says relay.
Checked power from GFCI to unit. Got 244.0 L1-L2
122.1 L1-G
122.8 L2-G
Seems like the ribbon cable going to the front from the board was the issue. We reseated it and the issue went away. So now we will see. I hope not to wake up to a van that wasn’t charged due to a fault that’s hard to pinpoint. But so far so good. I got 3 days until the van arrives. We will see then how it works out
I am the master electrician installing this for my shops new Ford E-Transit 350. Indoors at the panel. 60A std breaker (they don’t make GFCI for my square D panel for 60A 2P)
Line- Ran #6 to outdoor spa type 60A GFCI breaker.
Load of breaker to EVIQO charger. Removed factory wiring since it wouldn’t reach anyway. Ran thhn #6 in 1/2” Liquidtight to device. landed in device L1,L2,G connections.
Put everything together correctly. I’ve installed this same unit at a customer’s residence and it worked great.
Mine. Gave me an error. 8 flashes on the front of device. App says relay.
Checked power from GFCI to unit. Got 244.0 L1-L2
122.1 L1-G
122.8 L2-G
Seems like the ribbon cable going to the front from the board was the issue. We reseated it and the issue went away. So now we will see. I hope not to wake up to a van that wasn’t charged due to a fault that’s hard to pinpoint. But so far so good. I got 3 days until the van arrives. We will see then how it works out
Show more
